Texas Instruments SN74HC74DR

SN74HC74DR Overview
As a result, it is packaged as 14-SOIC (0.154, 3.90mm Width). The package Tape & Reel (TR)contains it. There is a Differentialoutput configured with it. The trigger configured with it uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. A 2V~6Vsupply voltage is required for it to operate. A temperature of -40°C~85°C TAis used in the operation. This logic flip flop is classified as type D-Type. The FPGA belongs to the 74HC series. It should not exceed 60MHzin terms of its output frequency. A total of 14terminations have been recorded. It is a member of the 74HC74 family. A voltage of 5V is used as the power supply for this D latch. Input capacitance of this device is 3pF farads. Devices in the HC/UHfamily are electronic devices. It is mounted in the way of Surface Mount. As you can see from the design, it has pins with 14. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The part you are looking for is included in FF/Latches. It reaches 6Vwhen the maximum supply voltage (Vsup) is applied. A normal operating voltage (Vsup) should remain above 2V. As a result of its reliable performance, this T flip flop is suitable for TR. For high efficiency, the supply voltage should be set to 5V. It offers maximum design flexibility with its output current of 5.2mA. Despite external influences, it consumes 4μAof quiescent current. It is reported that there are 2 channels. Inputs are set to 4.

SN74HC74DR Features
Tape & Reel (TR) package
74HC series
14 pins

SN74HC74DR Applications
There are a lot of Texas Instruments SN74HC74DR Flip Flops applications.

Frequency Divider circuits
Shift Registers
Single Up Count-Control Line
Guaranteed simultaneous switching noise level
Functionally equivalent to the MC10/100EL29
Pattern generators
ATE
Power down protection
Cold spare funcion
Control circuits