Texas Instruments SN74AUC1G80DBVR

SN74AUC1G80DBVR Overview
It is embeded in SC-74A, SOT-753 case. Package Cut Tape (CT)embeds it. T flip flop uses Invertedas the output. Positive Edgeis the trigger it is configured with. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 0.8V~2.7Vis used as the supply voltage. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 74AUCseries FPGA. A frequency of 275MHzshould not be exceeded by its output. It consumes 10μA of quiescent current without being affected by external factors. In 5terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. You can search similar parts based on 74AUC1G80. A voltage of 1.2V provides power to the D latch. There is 2.5pF input capacitance for this T flip flop. Devices in the AUCfamily are electronic devices. This electronic part is mounted in the way of Surface Mount. The 5pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. This flip flop is designed with 1 Bits. Vsup reaches its maximum value at 2.7V. Keeping the supply voltage (Vsup) above 0.8V is necessary for normal operation. Using 1 circuits, it is highly flexible. This D flip flop is well suited for TR based on its reliable performance.

SN74AUC1G80DBVR Features
Cut Tape (CT) package
74AUC series
5 pins
1 Bits

SN74AUC1G80DBVR Applications
There are a lot of Texas Instruments SN74AUC1G80DBVR Flip Flops applications.

ESD protection
Communications
Synchronous counter
Computers
Control circuits
Bounce elimination switch
Frequency division
Parallel data storage
Shift Registers
Data transfer