Texas Instruments SN74ALVCH16374DGGR

SN74ALVCH16374DGGR Overview
The flip flop is packaged in 48-TFSOP (0.240, 6.10mm Width). D flip flop is included in the Cut Tape (CT)package. T flip flop uses Tri-State, Non-Invertedas its output configuration. It is configured with a trigger that uses a value of Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 1.65V~3.6V. A temperature of -40°C~85°C TAis used in the operation. There is D-Type type of electronic flip flop associated with this device. FPGAs belonging to the 74ALVCHseries contain this type of chip. Its output frequency should not exceed 150MHz. In total, it contains 2 elements. A total of 48terminations have been recorded. D latch belongs to the 74ALVCH16374 family. The power supply voltage is 1.8V. A JK flip flop with a 3pFfarad input capacitance is used here. A device of this type belongs to the family of ALVC/VCX/A. There is an electronic part mounted in the way of Surface Mount. Basically, it is designed with a set of 48 pins. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchesfor the RS flip flops. The flip flop is designed with 16bits. Normally, the supply voltage (Vsup) should be kept above 1.65V. This D flip flop is well suited for TR based on its reliable performance. The flip flop contains 2ports. With a current output of 24mA , it offers maximum design flexibility. To operate, the chip has a total of 3 output lines. As a result, it consumes 40μA of quiescent current without being affected by external factors.

SN74ALVCH16374DGGR Features
Cut Tape (CT) package
74ALVCH series
48 pins
16 Bits

SN74ALVCH16374DGGR Applications
There are a lot of Texas Instruments SN74ALVCH16374DGGR Flip Flops applications.

Data transfer
Synchronous counter
Computers
Bounce elimination switch
Buffered Clock
Balanced Propagation Delays
Common Clocks
Dynamic threshold performance
QML qualified product
Load Control