Fairchild/ON Semiconductor MM74HC574MTC

MM74HC574MTC Overview
It is packaged in the way of 20-TSSOP (0.173, 4.40mm Width). There is an embedded version in the package Tube. The output it is configured with uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountmounts this electrical part. It operates with a supply voltage of 2V~6V. In this case, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. FPGAs belonging to the 74HCseries contain this type of chip. This D flip flop should not have a frequency greater than 35MHz. In total, there are 1 elements. There is a consumption of 8μAof quiescent energy. The number of terminations is 20. The 74HC574 family contains it. The power source is powered by 4.5V. Its input capacitance is 5pFfarads. A device of this type belongs to the family of HC/UH. Surface Mount mounts this electronic component. A total of 20pins are provided on this board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This device has the base part number FF/Latches. An electronic part designed with 8bits is used in this application. Vsup reaches 6V, the maximal supply voltage. Normal operation requires a supply voltage (Vsup) above 2V. Its flexibility is enhanced by 8 circuits. The power supply is 2/6V. A total of 2ports are embedded in the D flip flop. In order to operate, the chip has 3 output lines.

MM74HC574MTC Features
Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MM74HC574MTC Applications
There are a lot of ON Semiconductor MM74HC574MTC Flip Flops applications.

Individual Asynchronous Resets
Set-reset capability
Counters
Shift Registers
Data storage
Clock pulse
Matched Rise and Fall
Consumer
Patented noise
Frequency division