Texas Instruments CD74HC273M

CD74HC273M Overview
The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). The Tubepackage contains it. Currently, the output is configured to use Non-Inverted. The trigger configured with it uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. Powered by a 2V~6Vvolt supply, it operates as follows. In the operating environment, the temperature is -55°C~125°C TA. This electronic flip flop is of type D-Type. The 74HCseries comprises this type of FPGA. There should be no greater frequency than 60MHzon its output. In total, there are 1 elements. Currently, there are 20 terminations. D latch belongs to the 74HC273 family. It is powered from a supply voltage of 4.5V. This JK flip flop has a 10pFfarad input capacitance. HC/UHis the family of this D flip flop. This electronic part is mounted in the way of Surface Mount. Basically, it is designed with a set of 20 pins. This device exhibits a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. It is designed with 8bits. The maximal supply voltage (Vsup) reaches 6V. If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 2V. Using 8 circuits, it is highly flexible. It runs on 2/6Vvolts of power. As a result of its output current of 5.2mA, it is very flexible in terms of design. Despite external influences, it consumes 8μAof quiescent current.

CD74HC273M Features
Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

CD74HC273M Applications
There are a lot of Texas Instruments CD74HC273M Flip Flops applications.

Single Down Count-Control Line
Registers
Functionally equivalent to the MC10/100EL29
Frequency Dividers
Asynchronous counter
ESD protection
Divide a clock signal by 2 or 4
Synchronous counter
ESCC
ESD performance