Maxim Integrated DS1811-10 T&R

DS1811-10 T&R Overview
This power ic is packaged in a way that looks like a Tape & Reel (TR). Please refer to power management for TO-226-3, TO-92-3 (TO-226AA) (Formed Leads) functions. Compared to other Simple Reset/Power-On Reset products, this PMIC has a lot of benefits to offer. Power ics operate at 1 supply voltages. The power management is mounted by Through Hole. Power managment ic pin count is 3. Normally, the supply voltage (Vsup) for this PMIC should not be lower than 0V. There should be no more than 5.5V volts of supply voltage (Vsup) in this power management. Mounting type Through Hole is recommended. You should set the supervisor's temperature during -40°C~85°C TA . The output voltage of this power managment ic during operation is Open Drain or Open Collector. It is estimated that the voltage supervisor's supply current is 40μA. It is always advisable to use DS1811, the base supervisor number, when searching for similar PMICs from the manufacturer. A maximum supply temperature of 40μA can be used with this power management. As you may know, this PMIC comes from the well-known EconoReset series product line.

DS1811-10 T&R Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 0V
40μA operating supply current


DS1811-10 T&R Applications
There are a lot of Maxim Integrated
DS1811-10 T&R Voltage Supervisors applications.


Power distribution systems of ICU
Power distribution systems of CCU
emergency room
Medical-specific isolation transformer
Medical-specific insulation monitor
Transformer load monitoring equipment
External alarm
Display equipment
DC stabilized power supply module
Insulation fault location system