Texas Instruments XTR105UAG4

XTR105UAG4 Overview
Packaged in a SOIC case, the buffer op amp is ready to use. An op amp ic of the INSTRUMENTATION AMPLIFIER type. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 24V battery. I would like to specify that this buffer amplifier belongs to the Instrumentation Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 250μV for this buffer op amp. As long as the supply current of the chip does not exceed 20mA, this op amp ic can operate. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs Voltage signals. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 36V. A high supply voltage of more than 7.5V is recommended for the instrumentation amplifier's supply voltage.

XTR105UAG4 Features
14 Pins
supply voltage of 24V
Output Type: Voltage


XTR105UAG4 Applications
There are a lot of Texas Instruments
XTR105UAG4 Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection