Texas Instruments SN74LVTH162374DLR

SN74LVTH162374DLR Overview
The flip flop is packaged in 48-BSSOP (0.295, 7.50mm Width). D flip flop is embedded in the Cut Tape (CT) package. Tri-State, Non-Invertedis the output configured for it. In the configuration of the trigger, Positive Edgeis used. This electronic part is mounted in the way of Surface Mount. It operates with a supply voltage of 2.7V~3.6V. A temperature of -40°C~85°C TAis used in the operation. A flip flop of this type is classified as a D-Type. In terms of FPGAs, it belongs to the 74LVTH series. You should not exceed 160MHzin its output frequency. In total, it contains 2 elements. There is a consumption of 190μAof quiescent energy. 48terminations have occurred. This D latch belongs to the family of 74LVTH162374. The D flip flop is powered by a voltage of 3.3V . The input capacitance of this T flip flop is 3pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. In this case, the D flip flop belongs to the LVTfamily. The electronic part is mounted in the way of Surface Mount. The 48pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. The flip flop is designed with 16bits. It reaches the maximum supply voltage (Vsup) at 3.6V. As a result of its reliability, this D flip flop is ideally suited for TR. The D flip flop has no ports embedded. The supply voltage should be maintained at 3.3V for high efficiency. Its output current of 12mAallows for maximum design flexibility. It is designed with 8 output lines.

SN74LVTH162374DLR Features
Cut Tape (CT) package
74LVTH series
48 pins
16 Bits

SN74LVTH162374DLR Applications
There are a lot of Texas Instruments SN74LVTH162374DLR Flip Flops applications.

Memory
Shift registers
Cold spare funcion
High Performance Logic for test systems
Instrumentation
Clock pulse
Matched Rise and Fall
Test & Measurement
Consumer
Latch