Texas Instruments SN74LS74AD

SN74LS74AD Overview
The flip flop is packaged in a case of 14-SOIC (0.154, 3.90mm Width). D flip flop is included in the Tubepackage. It is configured with Differentialas an output. This trigger uses the value Positive Edge. There is an electric part mounted in the way of Surface Mount. Powered by a 4.75V~5.25Vvolt supply, it operates as follows. In this case, the operating temperature is 0°C~70°C TA. D-Typeis the type of this D latch. In terms of FPGAs, it belongs to the 74LS series. There should be no greater frequency than 33MHzon its output. A total of 14terminations have been recorded. It is a member of the 74LS74 family. A voltage of 5V provides power to the D latch. An electronic device belonging to the family LScan be found here. There is an electronic component mounted in the way of Surface Mount. This board has 14 pins. A Positive Edgeclock edge trigger is used in this device. The RS flip flops belongs to FF/Latches base part number. An electrical current of 5V volts is applied to it. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. This T flip flop features a maximum design flexibility due to its output current of 8mA. As of now, there are 3input lines. The number of channels is growing strong/weak: 2.

SN74LS74AD Features
Tube package
74LS series
14 pins
5V power supplies

SN74LS74AD Applications
There are a lot of Texas Instruments SN74LS74AD Flip Flops applications.

Differential Individual
Dynamic threshold performance
Power down protection
Count Modes
Convert a momentary switch to a toggle switch
Matched Rise and Fall
Individual Asynchronous Resets
ESD performance
Cold spare funcion
Buffer registers