Texas Instruments SN74F373N

SN74F373N Overview
It is embedded in the 20-DIP (0.300, 7.62mm) package. Tube is the packaging method. Tri-State is the output configured for it. There is D-Type Transparent Latch logic type for this electrical device. Mounting this electronic component follows the Through Hole method. There is no supply voltage for this device. There is 0°C~70°C operating temperature. It is a type of FPGA belonging to the 74F series. 8 Bits are used in the design of this electronic part. In this device, there are 20 terminations. This type belongs to the 74F373 family. The device works with a voltage of 5V for its supply voltage. The 20 pind are equipped with it. F/FAST is the family name of this electronic device. The 20 pins are designed into it. This electronic part is mounted in the way of Through Hole. This device has 2 ports on board, which are all available at the same time. The part is in the FF/Latches subcategory. There are 5V power supplies attached to it. In the circuit, there are 8 input lines that are constituted by an electronic circuit. With an output current of 24mA, it is highly flexible in terms of design. A high level of efficiency is achieved by maintaining the supply voltage at 5V. The current consumed by the device is 38mA volts in quiescent mode, which cannot be affected by external factors. In order for the device to operate at its maximum power, the maximum power current (ICC) of 55mA is needed for operation.

SN74F373N Features
20-DIP (0.300, 7.62mm) package
74F series
8 Bits
74F373 family
20 pin count
20 pins
5V power supplies

SN74F373N Applications
There are a lot of Texas Instruments SN74F373N Latches applications.

Automatic test equipment
Pattern generators
Shift Registers
General-Purpose Register
Flip-flops
Multistage ripple counting
Four-bit storage with output enable
Watches
Automotive Infotainment
Synchronous frequency dividers