Texas Instruments SN74AUC2G79DCUR

SN74AUC2G79DCUR Overview
It is embeded in 8-VFSOP (0.091, 2.30mm Width) case. D flip flop is included in the Tape & Reel (TR)package. This output is configured with Non-Inverted. This trigger is configured to use Positive Edge. It is mounted in the way of Surface Mount. A voltage of 0.8V~2.7Vis used as the supply voltage. The operating temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74AUCseries FPGA. It should not exceed 275MHzin its output frequency. It consumes 10μA of quiescent current without being affected by external factors. In 8terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. This D latch belongs to the family of 74AUC2G79. The D flip flop is powered by a voltage of 1.2V . Its input capacitance is 2.5pF farads. It is a member of the AUCfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. This board has 8 pins. This device exhibits a clock edge trigger type of Positive Edge. The part you are looking for is included in FF/Latches. The superior flexibility of this product is achieved by using 2 circuits. Considering its reliability, this T flip flop is well suited for TR. It has 1 output lines to operate.

SN74AUC2G79DCUR Features
Tape & Reel (TR) package
74AUC series
8 pins

SN74AUC2G79DCUR Applications
There are a lot of Texas Instruments SN74AUC2G79DCUR Flip Flops applications.

Modulo – n – counter
Memory
Registers
ESD protection
Divide a clock signal by 2 or 4
2 – Bit synchronous counter
Instrumentation
Load Control
Shift registers
Clock pulse