Fairchild/ON Semiconductor MM74HC374WM

MM74HC374WM Overview
The package is in the form of 20-SOIC (0.295, 7.50mm Width). As part of the package Tube, it is embedded. The output it is configured with uses Tri-State, Non-Inverted. This trigger is configured to use Positive Edge. There is an electric part mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. It is operating at -40°C~85°C TA. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74HC series. There should be no greater frequency than 35MHzon its output. In total, there are 1 elements. There have been 20 terminations. JK flip flop belongs to 74HC374 family. An input voltage of 4.5Vpowers the D latch. Its input capacitance is 5pF farads. This D flip flop belongs to the family of HC/UH. The electronic part is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. This device's clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The flip flop is designed with 8bits. There is a 6Vmaximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be kept above 2V. The system runs on a power supply of 2/6V watts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. In addition to its maximum design flexibility, the output current of the T flip flop is 7.8mA. In order to operate, the chip has 3 output lines. It consumes 8μA of quiescent current without being affected by external factors. 8is the number of channels.

MM74HC374WM Features
Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MM74HC374WM Applications
There are a lot of ON Semiconductor MM74HC374WM Flip Flops applications.

Asynchronous counter
Buffered Clock
Computing
Counters
Data Synchronizers
Clock pulse
Frequency division
Set-reset capability
Functionally equivalent to the MC10/100EL29
Bus hold