Texas Instruments LT1013DIDR

LT1013DIDR Overview
There is a 8-SOIC (0.154, 3.90mm Width) case package that contains the instrumentation amplifiers. There are two types of operational amplifiers in this circuit. There is a Cut Tape (CT) case that is delivered with the instrumentation amplifiers. The number of terminations approaches 8. Buffer amplifier has a total of 8 pins on it. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. 8 pins are available on the instrumentation amplifier. There is an input offset voltage of 200μV for this buffer op amp. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~105°C for optimal performance. An 350μA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain at 120dB. Op amp ic has 2 channels. The operating supply voltage of instrumentation amplifier is rated 22V voltage. As a result of this, the buffer amplifier is packed in TR.

LT1013DIDR Features
8 Pins
supply voltage of 15V
120dB voltage gain

LT1013DIDR Applications
There are a lot of Texas Instruments LT1013DIDR Instrumentational OP Amps applications.

Band-pass filter
Measurements of Wheatstone bridge
Cinema or auditorium audio system
Digital cameras
Instrumentation
Mobile phone
Broadcasting
earphone
Automotive sensors
Active probe