STMicroelectronics LM2904AYDT

LM2904AYDT Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. The op amp is delivered to you in a Tape & Reel (TR) case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 1mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~125°C . As long as the supply current of the chip does not exceed 700μA, this op amp ic can operate. 100dB should remain the voltage gain. The linear amplifier consists of 2 different elements in total. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted. As the name implies, Automotive, AEC-Q100 refers to the series of the buffer op amp.

LM2904AYDT Features
8 Pins
supply voltage of 5V
100dB voltage gain


LM2904AYDT Applications
There are a lot of STMicroelectronics
LM2904AYDT Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection