Texas Instruments LM2902N/NOPB

LM2902N/NOPB Overview
Packaged in a 14-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. The op amp is delivered to you in a Tube case. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 7mV for this buffer op amp. The mounting type that is recommended for this electrical part is Through Hole. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . As long as the supply current of the chip does not exceed 1.5mA, this op amp ic can operate. 100dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 4 channels. The operating supply voltage of the buffer op amp is rated at 13V.

LM2902N/NOPB Features
14 Pins
supply voltage of 5V
100dB voltage gain


LM2902N/NOPB Applications
There are a lot of Texas Instruments
LM2902N/NOPB Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection