Texas Instruments INA330AIDGSTG4

INA330AIDGSTG4 Overview
Packaged in a VSSOP case, the buffer op amp is ready to use. The op amp is delivered to you in a Tape & Reel (TR) case. There is a growing number of terminations approaching the number of 10. The pins on this board total to 10 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. A total of 10 pins are present on the instrumentation amplifier. There is an input offset voltage of 60μV for this buffer op amp. As long as the supply current of the chip does not exceed 2.6mA, this op amp ic can operate. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. The linear amplifier consists of 3 different elements in total. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 5.5V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. Currently, linear amplifier is operating with a quiescent current of 2.6mA. It should be noted that the other type of analog integrated circuit used in this instrumentation amplifier is known as the ANALOG CIRCUIT.

INA330AIDGSTG4 Features
10 Pins
supply voltage of 5V


INA330AIDGSTG4 Applications
There are a lot of Texas Instruments
INA330AIDGSTG4 Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection