Fairchild/ON Semiconductor FPF2143

Current Limit SW 1-IN 1-OUT 1.8V to 5.5V 6-Pin MLP EP T/R
Load Switch; Input Voltage Primary Max:5.5V; Output Current Max:200mA; Switch Resistance, Ron:120mohm; Thermal Protection:Yes; On/Enable Input Polarity:Active High; Power Dissipation, Pd:1.2W; Supply Voltage Min:1.8V ;RoHS Compliant: Yes
The FPF2140/42/43/44/46/47 is a series of load switches which provides full protection to systems and loads which may encounter large current conditions. These devices contain a 0.11Ω current-limited P-channel MOSFET which can operate over an input voltage range of 1.8-5.5V. Internally, current is prevented from flowing when the MOSFET is off and the output voltage is higher than the input voltage. Switch control is by a logic input (ON) capable of interfacing directly with low voltage control signals. Each part contains thermal shutdown protection which shuts off the switch to prevent damage to the part when a continuous over-current condition causes excessive heating. When the switch current reaches the current limit, the part operates in a constant-current mode to prohibit excessive currents from causing damage. For the FPF2140/42/44/46, if the constant current condition still persists after 30ms, the part will shut off the switch and pull the fault signal pin (FLAGB) low. The FPF2140/44 have an auto-restart feature which will turn the switch on again after 450ms if the ON pin is still active. The FPF2142/46 do not have this auto-restart feature so the switch will remain off until the ON pin is cycled. For the FPF2143/47, a current limit condition will immediately pull the fault signal pin low and the part will remain in the constant-current mode until the switch current falls below the current limit. The minimum current limit is 200mA for the FPF2140/42/43 while that for the FPF2144/46/47 is 400mA. These parts are available in a space-saving 6 pin 2X2 MLP package.