Rohm Semiconductor BD3181FVM-TR

BD3181FVM-TR Overview
Packaged in a 8-VSSOP, 8-MSOP (0.118, 3.00mm Width) case, the buffer op amp is ready to use. An op amp ic of the Current Sense type. The op amp is delivered to you in a Tape & Reel (TR) case. There is an input offset voltage of 500μV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -30°C~85°C . As long as the supply current of the chip does not exceed 1μA, this op amp ic can operate. During the manufacturing process, this buffer amplifier is divided into 1 circuits. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -30°C degrees Celsius. No temperature greater than 85°C should be used. As a result, it is recommended that a power supply of 1μA be used with this electronic part. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 30V. A high supply voltage of more than 3V is recommended for the instrumentation amplifier's supply voltage.

BD3181FVM-TR Features


BD3181FVM-TR Applications
There are a lot of ROHM Semiconductor
BD3181FVM-TR Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection