Texas Instruments 5962-9055701EA

CD14538B dual precision monostable multivibrator provides stable retriggerable/resettable one-shot operation for any fixed-voltage timing application.

An external resistor (R_X) and an external capacitor (C_X) control the timing and accuracy for the circuit. Adjustment of R_X and C_X provides a wide range of output pulse widths from the Q and Q\ terminals. The time delay from trigger input to output transition (trigger propagation delay) and the time delay from reset input to output transition (reset propagation delay) are independent of R_X and C_X. Precision control of output pulse widths is achieved through linear CMOS techniques.

Leading-edge-triggering ( TR) and trailing-edge-triggering (-TR) inputs are provided for triggering from either edge of an input pulse. An unused TR input should be tied to V_SS. An unused -TR input should be tied to V_DD. A RESET (on low level) is provided for immediate termination of the output pulse or to prevent output pulses when power is turned on. An unused RESET input should be tied to V_DD. However, if an entire section of the CD14538B is not used, its inputs must be tied to either V_DD or V_SS. See Table 1.

In normal operation the circuit retriggers (extends the output pulse one period) on the application of each new trigger pulse. For operation in the non-retriggerable mode, Q\ is connected to -TR when leading-edge triggering ( TR) is used or Q is connected to TR when trailing-edge triggering (-TR) is used. The time period (T) for this multivibrator can be calculated by: T = R_XC_X.

The minimum value of external resistance, R_X, is 4 K. The minimum and maximum values of external capacitance, C_X are 0 pF and 100µF, respectively.

The CD14538B is interchangeable with type MC14538 and is similar to and pin-compatible with the CD4098B* and CD4538B. It can replace the CD4538B which type is not recommended for new designs.

The CD14538B types are supplied in 16-lead hermetic dual-in-line ceramic packages (F3A suffix), 16-lead dual-in-line plastic packages (E suffix), 16-lead small-outline packages (M, M96, MT, and NSR suffixes), and 16-lead thin shrink small-outline packages (PW and PWR suffixes).