STMicroelectronics TSH310IDT

TSH310IDT Overview
A 8-SOIC (0.154, 3.90mm Width) case is used to package the op amp. Current Feedback-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 2.5V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 6.5mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~85°C . An 400μA volt supply current is needed for this linear amplifier to operate. There are a total of 1 elements in this linear amplifier. The instrumentation amplifier is packed in the form of TAPE AND REEL. The OptimWatt™ indicates the series number of the op amp.

TSH310IDT Features
8 Pins
supply voltage of 2.5V


TSH310IDT Applications
There are a lot of STMicroelectronics
TSH310IDT Instrumentational OP Amps applications.


Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement