Texas Instruments TL082IPWRG4

TL082IPWRG4 Overview
In order to protect the op amps, a TSSOP case is used. There are two types of operational amplifiers in this circuit. In the case of Tape and Reel cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. It has 8 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 6mV. In order for this instrumentation amplifier to operate, the supply current needs to be between 1.4mA and 10 . Maintain 106.02dB as the voltage gain. It is recommended that the temperature of this op amp ic should not fall below -40°C degrees Fahrenheit at any time. Linear amplifier shouldn't be used above 85°C degrees. As a whole, there are 2 elements that make up this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 18V. It is recommended that you conduct this electronic part using the dual supply voltage of 18V.

TL082IPWRG4 Features
8 Pins
supply voltage of 15V
106.02dB voltage gain


TL082IPWRG4 Applications
There are a lot of Texas Instruments
TL082IPWRG4 Instrumentational OP Amps applications.


Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification