Texas Instruments SN74LV574APWR

SN74LV574APWR Overview
The package is in the form of 20-TSSOP (0.173, 4.40mm Width). It is included in the package Cut Tape (CT). T flip flop uses Tri-State, Non-Invertedas its output configuration. JK flip flop uses Positive Edgeas the trigger. The electronic part is mounted in the way of Surface Mount. A voltage of 2V~5.5Vis required for its operation. The operating temperature is -40°C~85°C TA. It belongs to the type D-Typeof flip flops. This type of FPGA is a part of the 74LV series. It should not exceed 205MHzin its output frequency. In total, it contains 1 elements. A total of 20 terminations have been made. The 74LV574family includes it. A voltage of 2.5V is used as the power supply for this D latch. This JK flip flop has a 1.8pFfarad input capacitance. It is a member of the LV/LV-A/LVX/Hfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. The 20pins are designed into the board. This device has the clock edge trigger type of Positive Edge. This part is included in FF/Latches. There are 8bits in its design. Vsup reaches its maximum value at 5.5V. The supply voltage (Vsup) should be kept above 2V for normal operation. Its flexibility is enhanced by 8 circuits. In view of its reliability, this D flip flop is a good fit for TR. The flip flop contains 2ports. This T flip flop features a maximum design flexibility due to its output current of 16mA. This input has 3lines. It consumes a total of 20μA quiescent current at any given time.

SN74LV574APWR Features
Cut Tape (CT) package
74LV series
20 pins
8 Bits

SN74LV574APWR Applications
There are a lot of Texas Instruments SN74LV574APWR Flip Flops applications.

CMOS Process
Counters
Divide a clock signal by 2 or 4
Storage Registers
Pattern generators
Supports Live Insertion
Automotive
Synchronous counter
2 – Bit synchronous counter
Clock pulse