Texas Instruments SN74LS107AN

SN74LS107AN Overview
14-DIP (0.300, 7.62mm)is the packaging method. It is contained within the Tubepackage. As configured, the output uses Differential. The trigger configured with it uses Negative Edge. There is an electronic component mounted in the way of Through Hole. Powered by a 4.75V~5.25Vvolt supply, it operates as follows. 0°C~70°C TAis the operating temperature. This electronic flip flop is of type JK Type. This type of FPGA is a part of the 74LS series. Its output frequency should not exceed 45MHz. T flip flop consumes 6mA quiescent energy. Terminations are 14. The 74LS107 family contains it. A voltage of 5V provides power to the D latch. An electronic device belonging to the family LScan be found here. There is an electronic part that is mounted in the way of Through Hole. It is designed with 14 pins. It has a clock edge trigger type of Negative Edge. This device has the base part number FF/Latches. A power supply of 5Vis required to operate it. If high efficiency is desired, the supply voltage should be kept at 5V. With an output current of 8mA, it is possible to design the device in any way you want. This input has 4lines in it. Currently, there are 2 channels available.

SN74LS107AN Features
Tube package
74LS series
14 pins
5V power supplies

SN74LS107AN Applications
There are a lot of Texas Instruments SN74LS107AN Flip Flops applications.

Shift Registers
Frequency Divider circuits
Data transfer
Safety Clamp
Common Clocks
Single Down Count-Control Line
Data Synchronizers
Bus hold
High Performance Logic for test systems
Latch