Texas Instruments SN74HC74QPWRG4Q1

SN74HC74QPWRG4Q1 Overview
It is packaged in the way of 14-TSSOP (0.173, 4.40mm Width). The package Tape & Reel (TR)contains it. Differentialis the output configured for it. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis positioned in the way of this electronic part. The JK flip flop operates with an input voltage of 2V~6V volts. In the operating environment, the temperature is -40°C~125°C TA. This D latch has the type D-Type. In this case, it is a type of FPGA belonging to the Automotive, AEC-Q100, 74HC series. A frequency of 60MHzshould be the maximum output frequency. As a result, it consumes 4μA of quiescent current without being affected by external factors. The number of terminations is 14. JK flip flop belongs to 74HC74 family. Power is provided by a 5V supply. There is 3pF input capacitance for this T flip flop. Electronic devices of this type belong to the HC/UHfamily. The electronic part is mounted in the way of Surface Mount. As you can see from the design, it has pins with 14. There is a clock edge trigger type of Positive Edgeon this device. This device is part of the FF/Latchesbase part number family. The maximal supply voltage (Vsup) reaches 6V. Normally, the supply voltage (Vsup) should be above 2V. To achieve this superior flexibility, 2 circuits are used. A reliable performance of this D flip flop makes it well suited for use in TR. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It has 1 output lines to operate.

SN74HC74QPWRG4Q1 Features
Tape & Reel (TR) package
Automotive, AEC-Q100, 74HC series
14 pins

SN74HC74QPWRG4Q1 Applications
There are a lot of Texas Instruments SN74HC74QPWRG4Q1 Flip Flops applications.

Functionally equivalent to the MC10/100EL29
Parallel data storage
Shift Registers
Memory
2 – Bit synchronous counter
Asynchronous counter
Convert a momentary switch to a toggle switch
Matched Rise and Fall
Single Up Count-Control Line
Count Modes