Texas Instruments SN74HC74MPWREP

SN74HC74MPWREP Overview
14-TSSOP (0.173, 4.40mm Width)is the way it is packaged. D flip flop is embedded in the Tape & Reel (TR) package. It is configured with Differentialas an output. This trigger uses the value Positive Edge. Surface Mountis in the way of this electric part. The supply voltage is set to 2V~6V. -55°C~125°C TAis the operating temperature. This logic flip flop is classified as type D-Type. FPGAs belonging to the 74HCseries contain this type of chip. You should not exceed 60MHzin the output frequency of the device. This process consumes 4μA quiescents. It has been determined that there have been 14 terminations. You can search similar parts based on 74HC74. Power is provided by a 5V supply. There is 3pF input capacitance for this T flip flop. In terms of electronic devices, this device belongs to the HC/UHfamily of devices. It is mounted by the way of Surface Mount. There are 14pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The part is included in FF/Latches. As soon as Vsup reaches 6V, the maximum supply voltage is reached. Normally, the supply voltage (Vsup) should be above 2V. Due to its superior flexibility, it uses 2 circuits. This D flip flop is well suited for TR based on its reliable performance. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. It has 1 output lines to operate.

SN74HC74MPWREP Features
Tape & Reel (TR) package
74HC series
14 pins

SN74HC74MPWREP Applications
There are a lot of Texas Instruments SN74HC74MPWREP Flip Flops applications.

Divide a clock signal by 2 or 4
Safety Clamp
CMOS Process
Computers
Set-reset capability
Frequency division
Shift registers
Buffer registers
Frequency Divider circuits
Cold spare funcion