Texas Instruments SN74HC74D

SN74HC74D Overview
14-SOIC (0.154, 3.90mm Width)is the packaging method. The package Tubecontains it. It is configured with Differentialas an output. The trigger it is configured with uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. Powered by a 2V~6Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. This electronic flip flop is of type D-Type. The FPGA belongs to the 74HC series. This D flip flop should not have a frequency greater than 60MHz. A total of 14terminations have been recorded. The 74HC74 family contains it. It is powered from a supply voltage of 5V. This JK flip flop has a 3pFfarad input capacitance. The electronic device belongs to the HC/UHfamily. A part of the electronic system is mounted in the way of Surface Mount. With its 14pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. Vsup reaches its maximum value at 6V. Normally, the supply voltage (Vsup) should be above 2V. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. The output current of 5.2mA makes it feature maximum design flexibility. It consumes 4μA of quiescent current without being affected by external factors. There are 2 channels available. There are 4 inputs.

SN74HC74D Features
Tube package
74HC series
14 pins

SN74HC74D Applications
There are a lot of Texas Instruments SN74HC74D Flip Flops applications.

Latch
Counters
Shift registers
ESCC
Data transfer
Data storage
Storage registers
Storage Registers
Patented noise
Common Clocks