Texas Instruments SN74HC377DW

SN74HC377DW Overview
20-SOIC (0.295, 7.50mm Width)is the packaging method. You can find it in the Tubepackage. As configured, the output uses Non-Inverted. Positive Edgeis the trigger it is configured with. There is an electronic component mounted in the way of Surface Mount. Powered by a 2V~6Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In this case, it is a type of FPGA belonging to the 74HC series. A frequency of 64MHzshould not be exceeded by its output. The element count is 1 . T flip flop consumes 8μA quiescent energy. There are 20 terminations,The 74HC377 family contains it. The power supply voltage is 5V. This JK flip flop has a 3pFfarad input capacitance. In this case, the D flip flop belongs to the HC/UHfamily. A part of the electronic system is mounted in the way of Surface Mount. There are 20pins on it. This device has the clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. 8bits are used in its design. 6Vis the maximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be above 2V. It runs on 2/6Vvolts of power. In order to achieve high efficiency, the supply voltage should be maintained at 5V. It offers maximum design flexibility with its output current of 5.2mA. The number of input lines is 3. There is also a characteristic of WITH HOLD MODE. It is reported that there are 8 channels.

SN74HC377DW Features
Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC377DW Applications
There are a lot of Texas Instruments SN74HC377DW Flip Flops applications.

Individual Asynchronous Resets
Digital electronics systems
Data Synchronizers
2 – Bit synchronous counter
Supports Live Insertion
Storage Registers
Frequency division
Shift registers
Cold spare funcion
Patented noise