Texas Instruments SN74HC273DW

SN74HC273DW Overview
The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). You can find it in the Tubepackage. There is a Non-Invertedoutput configured with it. The trigger configured with it uses Positive Edge. The electronic part is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 2V~6V. Currently, the operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. The 74HCseries comprises this type of FPGA. A frequency of 60MHzshould be the maximum output frequency. Terminations are 20. This D latch belongs to the family of 74HC273. The D flip flop is powered by a voltage of 5V . There is 3pF input capacitance for this T flip flop. HC/UHis the family of this D flip flop. A part of the electronic system is mounted in the way of Surface Mount. A total of 20pins are provided on this board. In this device, the clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. Vsup reaches its maximum value at 6V. Normal operation requires a supply voltage (Vsup) above 2V. The supply voltage should be maintained at 5V for high efficiency. Its output current of 5.2mAallows for maximum design flexibility. There are 1 output lines in this JK flip flop. Currently, there are 2 lines of input. It consumes a total of 8μA quiescent current at any given time. As an additional reference, you may refer to electronic flip flop DUMMY VAL. There are 8 channels available.

SN74HC273DW Features
Tube package
74HC series
20 pins

SN74HC273DW Applications
There are a lot of Texas Instruments SN74HC273DW Flip Flops applications.

Set-reset capability
Power down protection
Memory
Dynamic threshold performance
Data storage
Count Modes
Shift registers
Parallel data storage
Cold spare funcion
EMI reduction circuitry