Texas Instruments SN74ALS574BN

SN74ALS574BN Overview
This particular component is manufactured by Texas Instruments and falls under the category of Logic - Flip Flops. It is a chip specifically designed for Logic - Flip Flops applications. The mounting type for this chip is Through Hole, meaning it is soldered onto the circuit board through holes. The package or case of the chip is 20-DIP (0.300, 7.62mm), indicating its physical dimensions. The supply voltage required for this chip to operate is 5V. The terminal pitch, which refers to the distance between the center of one terminal to the center of the next terminal, is 2.54mm. The output type of this chip is Tri-State, Non-Inverted, meaning it can have three different states: high, low, or high impedance. It is a non-inverted type, which means the output signal is the same as the input signal. This chip has two ports, allowing it to connect with other devices or components. The turn on delay time for this chip is 3 ns, indicating the time it takes for the output to respond after the input signal changes. The maximum I(ol), or output current, is 0.024 A, which is the maximum amount of current that can be drawn from the output pins. The height of this chip is 5.08mm, indicating its physical height when mounted on the circuit board. The thickness of the chip is 4.57mm, which refers to its physical thickness.

SN74ALS574BN Features
Tube package
74ALS series
20 pins
8 Bits
5V power supplies

SN74ALS574BN Applications
There are a lot of Texas Instruments SN74ALS574BN Flip Flops applications.

Consumer
Storage Registers
Frequency Divider circuits
Load Control
Control circuits
Digital electronics systems
Bus hold
ESCC
Divide a clock signal by 2 or 4
Event Detectors