Texas Instruments SN74ALS273DWR

SN74ALS273DWR Overview
The package is in the form of 20-SOIC (0.295, 7.50mm Width). You can find it in the Cut Tape (CT)package. T flip flop is configured with an output of Non-Inverted. The trigger it is configured with uses Positive Edge. Surface Mountmounts this electrical part. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. Currently, the operating temperature is 0°C~70°C TA. This logic flip flop is classified as type D-Type. In terms of FPGAs, it belongs to the 74ALS series. This D flip flop should not have a frequency greater than 35MHz. In total, there are 1 elements. As a result, it consumes 20mA of quiescent current without being affected by external factors. A total of 20 terminations have been made. Members of the 74ALS273family make up this object. It is powered from a supply voltage of 5V. It belongs to the family of electronic devices known as ALS. Electronic part Surface Mountis mounted in the way. It is designed with 20 pins. Its clock edge trigger type is Positive Edge. It is part of the FF/Latchbase part number family. The design is based on 8bits. Its superior flexibility is attributed to its use of 8 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. It runs on 5Vvolts of power. High efficiency requires the supply voltage to be maintained at 5V. The output current of 24mA makes it feature maximum design flexibility. Currently, there are 3 lines of input.

SN74ALS273DWR Features
Cut Tape (CT) package
74ALS series
20 pins
8 Bits
5V power supplies

SN74ALS273DWR Applications
There are a lot of Texas Instruments SN74ALS273DWR Flip Flops applications.

Set-reset capability
Supports Live Insertion
Shift registers
Bus hold
Convert a momentary switch to a toggle switch
Single Down Count-Control Line
Single Up Count-Control Line
Memory
Guaranteed simultaneous switching noise level
Individual Asynchronous Resets