Texas Instruments RC4558IDR

RC4558IDR Overview
In the package, you will find a 8-SOIC (0.154, 3.90mm Width)-case to contain the op amp ic. Op amps are General Purpose types of amplifier on the chip. A Tape & Reel (TR) case is used to deliver the buffer op amp. During the past two weeks, there have been close to 8 terminations. The pins on this board total to 8 in total. The linear amplifier should be run at 15V at all times, so please keep that in mind when using it. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. An 8-pin op amp ic is included in the package. As far as the input offset voltage is concerned, linear amplifier rates at 500μV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. With regard to operating temperature, op amp ranges -40°C~85°C. It is possible to operate this buffer amplifier from a supply current of 2.5mA . 109.54dB should be the voltage gain. Op amp ic has 2 channels. To pack the operational amplifier ics, TR is adopted as the packing method. As a result, linear amplifier's quiescent current is 2.8A.

RC4558IDR Features
8 Pins
supply voltage of 15V
109.54dB voltage gain

RC4558IDR Applications
There are a lot of Texas Instruments RC4558IDR Instrumentational OP Amps applications.

Differentiator circuits
Band-stop filter
Precision measurement
Voltage regulation circuit
Inverse/same-phase proportional circuit
single/dual op amp sum and difference circuits
Mobile phone
Fast A/D and D/A converters
Fission chambers
Power transmission