Texas Instruments OPA4344EA/250

OPA4344EA/250 Overview
There is a 14-TSSOP (0.173, 4.40mm Width) case in which the instrumentation amplifier is packaged. Buffer amps of this type are called General Purpose-types. A Cut Tape (CT) case is used to deliver the buffer op amp. The number of terminations is approaching the 14 mark. The total number of pins on linear amplifier is 14. The linear amplifier should be run at 5.5V at all times, so please keep that in mind when using it. In order to be more specific, this instrumentation amplifier is one of the types of Operational Amplifier devices. 14 pins are included on the operational amplifiers. As far as the input offset voltage is concerned, linear amplifier rates at 1mV. For this electronic part, it is recommended that you mount it with type Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureIt is possible to operate this buffer amplifier from a supply current of 150μA . 122dB should be the voltage gain. Op amp ic has 4 channels. A benefit of this op amp ic is that it outputs Rail-to-Rail signals, which is one of the many advantages it has to offer. For the packing of the instrumentation amplifier, TR is adopted. The MicroAmplifier™ represents the op amp's series number.

OPA4344EA/250 Features
14 Pins
supply voltage of 5.5V
122dB voltage gain
Output Type: Rail-to-Rail


OPA4344EA/250 Applications
There are a lot of Texas Instruments
OPA4344EA/250 Instrumentational OP Amps applications.


Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control