Texas Instruments OPA347SA/3K

OPA347SA/3K Overview
Packaged in a 5-TSSOP, SC-70-5, SOT-353 case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. The op amp is delivered to you in a Cut Tape (CT) case. There is a growing number of terminations approaching the number of 5. The pins on this board total to 5 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 5 pins are present on the instrumentation amplifier. There is an input offset voltage of 6mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -55°C~125°C . 115dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs Rail-to-Rail signals. For packing the buffer amplifier, the TR-axis is adopted. As a result, it is recommended that a power supply of 20μA be used with this electronic part.

OPA347SA/3K Features
5 Pins
supply voltage of 5V
115dB voltage gain
Output Type: Rail-to-Rail


OPA347SA/3K Applications
There are a lot of Texas Instruments
OPA347SA/3K Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection