Texas Instruments OPA2604APG4

OPA2604APG4 Overview
In the package, you will find a PDIP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 15V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. Op amp rates 5mV as input offset voltage. Using an 10.5mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 100dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -25°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. 2 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 24V. The linear amplifier is packaged by using a TUBE axis. This electrical part should be conducted under the dual supply voltage of 24V volts when you conduct this part.

OPA2604APG4 Features
8 Pins
supply voltage of 15V
100dB voltage gain


OPA2604APG4 Applications
There are a lot of Texas Instruments
OPA2604APG4 Instrumentational OP Amps applications.


Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering
Signal operation
Video computer boards