Microchip Technology MCP1403-E/SN

Description
The MCP1403/4/5 are a family of dual-inverting, dual-non-inverting, or complimentary output drivers. They can deliver high peak currents of 4.5A typically into capacitive loads. These devices also feature low shoot-through current, matched rise/fall times, and propagation delays.
The MCP1403/4/5 drivers operate from a 4.5V to 18V single power supply and can easily charge and discharge 2200 pF gate capacitance in under 15 ns (typ). They provide low enough impedances in both the on and off states to ensure the MOSFETs intended state will not be affected, even by large transients. The input to the MCP1403/4/5 may be driven directly from either TTL or CMOS (3V to 18V).
The MCP1403/4/5 dual-output 4.5A driver family is offered in both surface-mount and pin-through-hole packages with a -40°C to 125°C temperature rating. The low thermal resistance of the thermally enhanced DFN package allows for greater power dissipation capability for driving heavier capacitive or resistive loads.
These devices are highly latch-up resistant under any conditions within their power and voltage ratings. They are not subject to damage when up to 5V of noise spiking (of either polarity) occurs on the ground pin. All terminals are fully protected against Electrostatic Discharge (ESD) up to 4 KV.

Features
4.5A Dual High-Speed Power MOSFET Drivers
High Peak Output Current: 4.5A (typ.)
Low Shoot-Through/Cross-Conduction Current in Output Stage
Wide Input Supply Voltage Operating Range: - 4.5V to 18V
High Capacitive Load Drive Capability:
2200 pF in 15 ns
5600 pF in 34 ns
Short Delay Times: 40 ns (typ.)
Low Supply Current:
With Logic '1' Input - 1.0 mA (typ.)
With Logic '0' Input - 150 μA (typ.)
Latch-Up Protected: Will Withstand 1.5A Reverse Current
Logic Input Will Withstand Negative Swing Up To 5V
Packages: 8-Pin SOIC, PDIP, 8-Pin 6x5 DFN, and 16-Pin SOIC

Applications
Switch Mode Power Supplies
Pulse Transformer Drive
Line Drivers
Motor and Solenoid Drive