ON Semiconductor MC74HC4066ADR2G

MC74HC4066ADR2G Overview
The electronic component is convenient to ship overseas because it is packed in a 14-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Increasing operating temperature to around -55°C~125°C TA. 14 terminations have been made so far. By its 1 channels, the electronic component provides high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. A key feature of the 14 series is the inclusion of this electronic part as part of its design. Unlike digital switches, these are based on SPST - NO switching circuits. Try searching for MC74HC4066A variants of the analog switch ic. As far as internal resistance is concerned, it has 120Ohm. To find out what the functions of 14 pins are, please refer to their datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 12V. Analogue multiplexers of the Dual supply type that are cost-effective. The lowest voltage the electronic part should receive is 2V. An operating current of 40μA would be sufficient for this switch device. A voltage of 2V~12V is required for this switch device, which drains from a single voltage source. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. In order to operate the 4 inputs, there are several steps to follow. The transfer of data can be performed over 160MHz bandwidths.

MC74HC4066ADR2G Features
1 Channels
Switch Circuit: SPST - NO
40μA Supply Current
Bandwidth: 160MHz

MC74HC4066ADR2G Applications
There are a lot of ON Semiconductor MC74HC4066ADR2G Analog Switches & Multiplexers ICs applications.

DSLAMs
Cellular phones
Digital access cross connects
Fault Tolerant Systems
Multiplexers
Voice over IP/DSL – Integrated Access Devices, Smart
Existing multiplexer applications (both fault-protected and nonfault-protected)
Audio and video switching
FTTH
PDH Multiplexers