Maxim Integrated MAX4852ETE T

MAX4852ETE T Overview
As the electronic part is packed in 16-WFQFN Exposed Pad, international shipping is convenient. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexer and demultiplexer circuits have a number 2:1. Operational temperature extended around -40°C~85°C TA. Totally, there are 16 terminations. A electrical component with 1 channels is capable of high-quality output. If the voltage supply is 3V volts, the electrical component should be turned on and run. There is an electrical component included in the 16 series. Unlike digital switches, these are based on SPDT switching circuits. A total of 2 circuits make up this switch device. Try searching for MAX4852 variants of the analog switch ic. This digital multiplexer has 4.5Ohm internal resistance. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. The analog switch ic is of the Single supply type and is cost-effective. There should be 2V voltage fed to the electrical part below 2V. For this digital switch to work, 1μA current would suffice. The voltage required by this switch device is 2V~5.5V, draining from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. Operating voltages range from 5V.

MAX4852ETE T Features
1 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 100MHz

MAX4852ETE T Applications
There are a lot of Maxim Integrated MAX4852ETE T Analog Switches & Multiplexers ICs applications.

DVD-R
Cellular phones
Signal routing between systems
Ultrasound
Frame Relay Equipment
ISDN NT1/TA
T1/E1 Terminals
Battery Powered Systems
PCMCIA cards
PBX interfaces