Home > Products > Integrated Circuits (ICs) > Interface - Analog Switches, Multiplexers, Demultiplexers > MAX4717EUB
MAX4717EUB

Maxim Integrated MAX4717EUB

Part Number:
MAX4717EUB
Manufacturer:
Maxim Integrated
Ventron No:
3164344-MAX4717EUB
Description:
IC SWITCH SPDT 10UMAX
ECAD Model:
Datasheet:
MAX4717EUB

Quick Request Quote

Please send RFQ , We will respond immediately.

Part Number
Quantity
Company
E-mail
Phone
Comments
Specifications
Maxim Integrated MAX4717EUB technical specifications, attributes, parameters and parts with similar specifications to Maxim Integrated MAX4717EUB .
  • Factory Lead Time
    6 Weeks
  • Mount
    Surface Mount
  • Mounting Type
    Surface Mount
  • Package / Case
    10-TFSOP, 10-MSOP (0.118, 3.00mm Width)
  • Number of Pins
    10
  • Operating Temperature
    -40°C~85°C TA
  • Packaging
    Tube
  • Published
    2005
  • JESD-609 Code
    e3
  • Pbfree Code
    yes
  • Part Status
    Active
  • Moisture Sensitivity Level (MSL)
    1 (Unlimited)
  • Number of Terminations
    10
  • ECCN Code
    EAR99
  • Resistance
    4.5Ohm
  • Terminal Finish
    Matte Tin (Sn)
  • Subcategory
    Multiplexer or Switches
  • Max Power Dissipation
    444mW
  • Technology
    BICMOS
  • Terminal Position
    DUAL
  • Terminal Form
    GULL WING
  • Peak Reflow Temperature (Cel)
    260
  • Number of Functions
    2
  • Supply Voltage
    3V
  • Terminal Pitch
    0.5mm
  • Reflow Temperature-Max (s)
    30
  • Base Part Number
    MAX4717
  • Output
    SEPARATE OUTPUT
  • Pin Count
    10
  • Power Supplies
    3/5V
  • Number of Channels
    1
  • Number of Circuits
    2
  • Max Supply Voltage
    5.5V
  • Min Supply Voltage
    1.8V
  • Operating Supply Current
    1μA
  • Max Supply Current
    1μA
  • Turn On Delay Time
    80 ns
  • Supply Type
    Single
  • Bandwidth
    300MHz
  • Turn-Off Delay Time
    40 ns
  • On-State Resistance (Max)
    4.5Ohm
  • Multiplexer/Demultiplexer Circuit
    2:1
  • Off-state Isolation-Nom
    55 dB
  • Current - Leakage (IS(off)) (Max)
    500pA
  • Channel Capacitance (CS(off), CD(off))
    9pF
  • On-state Resistance Match-Nom
    0.1Ohm
  • Switch Circuit
    SPDT
  • Switch Time (Ton, Toff) (Max)
    80ns, 40ns
  • Charge Injection
    5pC
  • Channel-to-Channel Matching (ΔRon)
    100m Ω
  • Crosstalk
    -110dB @ 1MHz
  • Switching
    BREAK-BEFORE-MAKE
  • Voltage - Supply, Single (V )
    1.8V~5.5V
  • Height
    950μm
  • Length
    3.05mm
  • Width
    3.05mm
  • Radiation Hardening
    No
  • REACH SVHC
    Unknown
  • RoHS Status
    ROHS3 Compliant
Description
MAX4717EUB Overview
Presented in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tube. Multiplexers like this are mounted in the Surface Mount position. 2:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. The total number of terminations is 10. High-quality output is provided by the electronic component's 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. Into the electrical component body are injected 10 pins. Unlike digital switches, these are based on SPDT switching circuits. There are 2 circuits in this switch device. MAX4717 can be used to search for analog multiplexer variants. As far as internal resistance is concerned, it has 4.5Ohm. To find out what the functions of 10 pins are, please refer to their datasheets. In this analog multiplexer, the value is Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Analog switch ics with Single supply type are cost-effective. In order for the electronic part to function properly, the lowest voltage should be 1.8V. 1μA current would be enough for this multiplexer to operate. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. It is possible to transfer data over a 300MHz-bandwidth.

MAX4717EUB Features
1 Channels
Switch Circuit: SPDT
1μA Supply Current
Bandwidth: 300MHz

MAX4717EUB Applications
There are a lot of Maxim Integrated MAX4717EUB Analog Switches & Multiplexers ICs applications.

Automotive applications
MP3 players
Digital Cross-Connects
Data Acquisition Systems
High-Voltage
SDH/SONET multiplexers
Precision data acquisition
PBXs
Signal routing between systems
Digital access cross connects
MAX4717EUB More Descriptions
MAX4717 Series SPDT 5.5 V 4.5 Ohm Surface Mount Analog Switch - UMAX-10
ANALOGUE SWITCH, DUAL, UMAX-10; No. of Channels: 2Channels; Analogue Switch Type: SPDT; On State Resistance Max: 2ohm; Supply Voltage Range: 1.8V to 5.5V; Analogue Switch Case: µMAX; No. of Pins: 10Pins; Operating Temperature
Analog Switch / Multiplexer (Mux) IC; Analog Switch Type:SPDT; Voltage Supply Source:Single; On State Resistance Max:3ohm; Supply Voltage Min:1.8V; Supply Voltage Max:5.5V; Termination Type:SMD; Package/Case:10-uMAX; No. of Pins:10 ;RoHS Compliant: Yes
Certification
  • ISO 9001
  • ISO 13485
  • ISO 45001
  • ASA
  • ESD
  • DUNS
  • SMTA
  • ROHS
Popular Search Part Number Related Keywords Search Tags

Latest News

  • cost

    Help you to save your cost and time.

  • package

    Reliable package for your goods.

  • fast

    Fast Reliable Delivery to save time.

  • service

    Quality premium after-sale service.