Linear LT1215CN8

LT1215CN8 Overview
A DIP case is used to package the op amp. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 125μV. An 5.7mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. On this instrumentation amplifier, there are 2 circuits that are connected together. There are 2 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than 0°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 70°C. There are a total of 2 elements in this linear amplifier. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 2.5V at all times. The dual supply voltage of 18V should be used for the conduct of this electronic component.

LT1215CN8 Features
115.56dB voltage gain


LT1215CN8 Applications
There are a lot of Analog Devices, Inc.
LT1215CN8 Instrumentational OP Amps applications.


Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement