STMicroelectronics LS404IN

LS404IN Overview
A 14-DIP (0.300, 7.62mm) case is used to package the op amp. General Purpose-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tube case. It is estimated that there will be 14 terminations in the next few months. There are a total of 14 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 15V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 14 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 2.5mV. It is recommended that this electronic component be mounted using the Through Hole mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~105°C . An 1.3mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. On this instrumentation amplifier, there are 4 circuits that are connected together. There are 2 channels on the operational amplifiers. The operating supply voltage of the buffer op amp is rated at 15V. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 6V at all times. The dual supply voltage of 18V should be used for the conduct of this electronic component.

LS404IN Features
14 Pins
supply voltage of 15V
100dB voltage gain


LS404IN Applications
There are a lot of STMicroelectronics
LS404IN Instrumentational OP Amps applications.


Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement