Texas Instruments LMC6032IN/NOPB

LMC6032IN/NOPB Overview
Packaged in a 8-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. The op amp is delivered to you in a Tube case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 9mV for this buffer op amp. The mounting type that is recommended for this electrical part is Through Hole. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . As long as the supply current of the chip does not exceed 750μA, this op amp ic can operate. 126.02dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. The operating supply voltage of the buffer op amp is rated at 15V.

LMC6032IN/NOPB Features
8 Pins
supply voltage of 5V
126.02dB voltage gain


LMC6032IN/NOPB Applications
There are a lot of Texas Instruments
LMC6032IN/NOPB Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection