Texas Instruments INA337AIDGKRG4

INA337AIDGKRG4 Overview
A VSSOP case is used to package the op amp. INSTRUMENTATION AMPLIFIER-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tape and Reel case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 5V volts. It should be noted that this op amp is a type of Instrumentation Amplifier device. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 100μV. An 2.4mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. There are 1 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 125°C. There are a total of 3 elements in this linear amplifier. I would like to point out that this electrical component is capable of working from a voltage below 5.5V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 2.7V at all times. There is a quiescent current of 2.4mA in this operational amplifier circuit. 10GOhm should be the range of resistance for the linear amplifier.

INA337AIDGKRG4 Features
8 Pins
supply voltage of 5V
80dB voltage gain
Resistance of 10GOhm


INA337AIDGKRG4 Applications
There are a lot of Texas Instruments
INA337AIDGKRG4 Instrumentational OP Amps applications.


Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement