Texas Instruments INA132UAG4

INA132UAG4 Overview
Packaged in a SOIC case, the buffer op amp is ready to use. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 750μV for this buffer op amp. As long as the supply current of the chip does not exceed 160μA, this op amp ic can operate. 0dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. The linear amplifier consists of 1 different elements in total. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 36V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts. Currently, linear amplifier is operating with a quiescent current of 160μA. Instrumentation amplifier resistance should stay within the range of 80kOhm. It should be noted that the other type of analog integrated circuit used in this instrumentation amplifier is known as the ANALOG CIRCUIT. It is important to note that this buffer op amp also has the following extra benefit: IT CAN ALSO OPERATE WITH 2.7V TO 36V SINGLE SUPPLY.

INA132UAG4 Features
8 Pins
supply voltage of 15V
0dB voltage gain
Resistance of 80kOhm


INA132UAG4 Applications
There are a lot of Texas Instruments
INA132UAG4 Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection