Texas Instruments INA110KU

INA110KU Overview
Packaged in a 16-SOIC (0.295, 7.50mm Width) case, the buffer op amp is ready to use. An op amp ic of the Instrumentation type. The op amp is delivered to you in a Tube case. There is a growing number of terminations approaching the number of 16. The pins on this board total to 16 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 16 pins are present on the instrumentation amplifier. There is an input offset voltage of 1mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of 0°C~70°C . As long as the supply current of the chip does not exceed 3mA, this op amp ic can operate. 58.06dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. The linear amplifier consists of 3 different elements in total. Currently, linear amplifier is operating with a quiescent current of 3mA. Instrumentation amplifier resistance should stay within the range of 5 TΩ.

INA110KU Features
16 Pins
supply voltage of 15V
58.06dB voltage gain
Resistance of 5 TΩ


INA110KU Applications
There are a lot of Texas Instruments
INA110KU Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection