Texas Instruments CY74FCT821CTQCT

CY74FCT821CTQCT Overview
The package is in the form of 24-SSOP (0.154, 3.90mm Width). As part of the package Cut Tape (CT), it is embedded. As configured, the output uses Tri-State, Non-Inverted. Positive Edgeis the trigger it is configured with. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis required for its operation. A temperature of -40°C~85°C TAis considered to be the operating temperature. It is an electronic flip flop with the type D-Type. In terms of FPGAs, it belongs to the 74FCT series. A total of 1 elements are present. There is a consumption of 200μAof quiescent energy. There are 24 terminations,You can search similar parts based on 74FCT821. A voltage of 5V is used to power it. Its input capacitance is 5pFfarads. Devices in the FCTfamily are electronic devices. There is an electronic component mounted in the way of Surface Mount. There are 24pins on it. In this device, the clock edge trigger type is Positive Edge. The RS flip flops belongs to FF/Latches base part number. An electronic part designed with 10bits is used in this application. As a result of its reliability, this D flip flop is ideally suited for TR. It operates from 5V power supplies. The flip flop has 2embedded ports. High efficiency requires the supply voltage to be maintained at 5V. With an output current of 64mA, this device offers maximum design flexibility. In order to operate, the chip has 3 output lines. There are 10 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.

CY74FCT821CTQCT Features
Cut Tape (CT) package
74FCT series
24 pins
10 Bits
5V power supplies

CY74FCT821CTQCT Applications
There are a lot of Texas Instruments CY74FCT821CTQCT Flip Flops applications.

Bounce elimination switch
Bus hold
Load Control
ATE
Single Up Count-Control Line
Consumer
Memory
Individual Asynchronous Resets
Control circuits
Safety Clamp