Texas Instruments CY74FCT574CTSOC

CY74FCT574CTSOC Overview
As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). Package Tubeembeds it. There is a Tri-State, Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. Surface Mountis positioned in the way of this electronic part. A voltage of 4.75V~5.25Vis required for its operation. -40°C~85°C TAis the operating temperature. This logic flip flop is classified as type D-Type. In terms of FPGAs, it belongs to the 74FCT series. In total, it contains 1 elements. There is a consumption of 200μAof quiescent energy. A total of 20 terminations have been made. This D latch belongs to the family of 74FCT574. Power is provided by a 5V supply. A 5pFfarad input capacitance is provided by this T flip flop. It belongs to the family of electronic devices known as FCT. The electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. A Positive Edgeclock edge trigger is used in this device. It is part of the FF/Latchesbase part number family. Flip flops designed with 8bits are used in this part. Despite its superior flexibility, it relies on 8 circuits to achieve it. A total of 5V power supplies are needed to run it. There are 2 ports embedded in the flip flops. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. Its output current of 64mAallows for maximum design flexibility. It has 3 output lines to operate. The frequency that can be achieved is 250MHz.

CY74FCT574CTSOC Features
Tube package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT574CTSOC Applications
There are a lot of Texas Instruments CY74FCT574CTSOC Flip Flops applications.

Convert a momentary switch to a toggle switch
Counters
Buffered Clock
Frequency Dividers
ESCC
Parallel data storage
Pattern generators
ATE
Balanced 24 mA output drivers
Asynchronous counter