Texas Instruments CD74HC273E

CD74HC273E Overview
As a result, it is packaged as 20-DIP (0.300, 7.62mm). You can find it in the Tubepackage. T flip flop uses Non-Invertedas the output. It is configured with the trigger Positive Edge. There is an electric part mounted in the way of Through Hole. A supply voltage of 2V~6V is required for operation. Temperature is set to -55°C~125°C TA. It belongs to the type D-Typeof flip flops. It belongs to the 74HCseries of FPGAs. Its output frequency should not exceed 60MHz Hz. In total, it contains 1 elements. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. Members of the 74HC273family make up this object. It is powered by a voltage of 4.5V . Its input capacitance is 10pFfarads. An electronic device belonging to the family HC/UHcan be found here. There is an electronic part that is mounted in the way of Through Hole. There are 20pins on it. Its clock edge trigger type is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. The design is based on 8bits. Vsup reaches its maximum value at 6V. The supply voltage (Vsup) should be kept above 2V for normal operation. The superior flexibility is achieved through the use of 8 circuits. There are 2/6V power supplies attached to it. This T flip flop features a maximum design flexibility due to its output current of 5.2mA. There is 8μA quiescent current consumption by it.

CD74HC273E Features
Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

CD74HC273E Applications
There are a lot of Texas Instruments CD74HC273E Flip Flops applications.

Divide a clock signal by 2 or 4
Event Detectors
Frequency Divider circuits
Buffer registers
Memory
High Performance Logic for test systems
Matched Rise and Fall
Digital electronics systems
Guaranteed simultaneous switching noise level
Safety Clamp