Texas Instruments CD74ACT374M96

CD74ACT374M96 Overview
The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). As part of the package Cut Tape (CT), it is embedded. Tri-State, Non-Invertedis the output configured for it. There is a trigger configured with Positive Edge. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. It is operating at a temperature of -55°C~125°C TA. The type of this D latch is D-Type. In this case, it is a type of FPGA belonging to the 74ACT series. A frequency of 110MHzshould be the maximum output frequency. In total, it contains 1 elements. A total of 20 terminations have been made. If you search by 74ACT374, you will find similar parts. The D flip flop is powered by a voltage of 5V . Its input capacitance is 10pF farads. It belongs to the family of electronic devices known as ACT. The electronic part is mounted in the way of Surface Mount. There are 20pins on it. The clock edge trigger type for this device is Positive Edge. This RS flip flops is a part number FF/Latches. It is designed with 8bits. In order to achieve its superior flexibility, 8 circuits are used. Due to its reliability, this T flip flop is well suited for TR. It runs on 5Vvolts of power. There are 2 ports embedded in the flip flops. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. The 24mA output current allows it to be designed with the greatest amount of flexibility. In order to operate, the chip has 3 output lines. It consumes 8μA of quiescent current without being affected by external factors.

CD74ACT374M96 Features
Cut Tape (CT) package
74ACT series
20 pins
8 Bits
5V power supplies

CD74ACT374M96 Applications
There are a lot of Texas Instruments CD74ACT374M96 Flip Flops applications.

Consumer
Synchronous counter
Balanced Propagation Delays
Instrumentation
Load Control
Differential Individual
ESCC
Computers
Data Synchronizers
Circuit Design