Rohm Semiconductor BU7487F-E2

BU7487F-E2 Overview
Packaged in a 14-SOIC (0.173, 4.40mm Width) case, the buffer op amp is ready to use. An op amp ic of the CMOS type. The op amp is delivered to you in a Tape & Reel (TR) case. There is a growing number of terminations approaching the number of 14. I would like to remind you that this buffer op amp should be powered by an 3V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 1mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~105°C . As long as the supply current of the chip does not exceed 6mA, this op amp ic can operate. During the manufacturing process, this buffer amplifier is divided into 4 circuits.

BU7487F-E2 Features
supply voltage of 3V


BU7487F-E2 Applications
There are a lot of ROHM Semiconductor
BU7487F-E2 Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection