Texas Instruments TPS2410PW

TPS2410PW Overview
The case comes with it. Packing the part in Tube cases is ideal. There is a Surface Mount-axis mounted on the part. A voltage of 3V~16.5V is applied to it. In order for this component to operate correctly, its minimum operating temperature must not be -40°C~85°C. The component connected to N 1 Power Supplies, High Availability is a good match for this component. Device N 1 ORing Controller belongs to the N 1 ORing Controller category. As far as FET types are concerned, N-Channel can be recognized. In this part, there are 14 terminations. 14 pins are used in the design of this product. Based on TPS2410, this part is manufactured. This device is powered by 5V in order to deliver a high level of performance. In order to run 260, a part's peak reflow temperature is utilized. It is necessary to run the supply current of the part at 4.25mA in order to make it work. Part of the Power Management Circuits family. It is important to note that the part has 14 pins. A voltage supply (Vsup) that is less than 3V should not be used for this part. This chip can be used with an input voltage of more than 16.5V volts without any problems. There are only a few chips on the market that can be used with an input voltage lower than 800mV volts. A maximum output voltage of 10.2V can be obtained from this device. 1.2mA utilizes quiescent current.

TPS2410PW Features
in a 14-TSSOP (0.173, 4.40mm Width) case
FET Type: N-Channel
14 terminations
Peak Reflow Temperature (Cel) : 260

TPS2410PW Applications
There are a lot of Texas Instruments TPS2410PW Ideal Diode controller applications.

Alternator
Building automation
Camera ECU
Active OR-ing of Redundant (N 1) Power Supplies
Digital Cameras
PDAs
ADAS domain controller
Automotive infotainment systems - head unit,telematics control unit
Active ORing for redundant power supplies
AC Rectifier